#Mini excavator replacement bucket how to#
#Mini excavator replacement bucket full#

Insert a new pin that comes with the tooth by pushing it through the holes with a hammer. Insert the new tooth and ensure that the holes on the tooth and the ones on the shank are aligned. This will ensure that you can insert the new one without obstacles and you can work your excavator’s bucket without the risk of damaging the teeth’s shank. Clean the ShankĬlean the shank and remove any debris. 2022 BOBCAT 12' TOOTH BUCKET USES A STANDARD 156 TOOTH FOR EASY REPLACEMENT FITS THE FOLLOWING BOBCAT MINI EXCAVATOR MODELS W/ X-CHANGE SYSTEM. Once the pin has been removed, slide the old tooth out of the shank. Remove the old pin from the tooth using a punch and a hammer. Often the majority of these tools come with the new tooth. Gather Your Toolsįor this, you will need a new pin, a new tooth, a hammer, and a punch.

#Mini excavator replacement bucket how to#

How to Change Teeth on Excavator BucketĪs well as the bucket, it is essential to change the excavator bucket’s teeth before they start damaging the shank.

This will ensure that the bucket is not faulty and adequate for the excavator.

#Mini excavator replacement bucket full#

Once everything is in position, use the ram and the dipper to rotate the new bucket through its full range of motion. Check the Results and Grease the PinsĬheck that all pins are perfectly in place and they are greased. This movement will cause the dipper end pinhole to align with the front bucket pivot pinholes. Retract the ram and, while doing so, position the dipper at an angle. Slowly Retract the Ram and Insert the Front Pin The movement will ensure that the pin falls into place. Once the pin is inserted, you can start lifting the dipper until the bucket is hovering just above the ground. Now that the pivots are aligned insert the rear bucket pin. Then, align the pinhole with the pivot pinholes at the rear of the bucket. Start by dropping the bucket link towards the bucket’s rear pivot. Maneuver the dipper, so it stands vertically above the bucket pivots. This ensures that the dipper can reach it while in a vertical position. Ideally, the bucket should be in line with the excavator and positioned at mid-reach. To swap the old bucket for a new one, start by positioning the new bucket on a flat, level surface. Then, remove the safety pin and lift the dipper. You can do so by using the excavator controls to place the bucket on a level surface or floor. You can do so in nine steps – here’s how. 9 Easy Steps to Change an Excavator Bucketįirst off, let’s have a look at how to swap your excavator’s bucket for a new one or for a more suitable one for your project. However, following the right instructions is crucial to avoid damaging the excavator and maintain high levels of safety. The two procedures (changing the bucket or the teeth) are not challenging. Also, often, you will need to swap the bucket you are using for a more suitable one, according to the project you are working on. But, checking the bucket and teeth and ensuring that they are not causing damage to the shank or main structure of the excavator is essential. Excavators can last forever with the right maintenance.